LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Engine Mechanical - 6.7L Diesel) >> Disassembly And Assembly Of Subassemblies >> Cylinder Head >> Assembly

Cylinder Head: Assembly

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Lubricate the valve seal assembly with clean engine oil prior to installing.
    NOTE: The valve seal assembly will not seat completely by hand. The Valve Spring Compressor will seat the valve seal assembly when installing the valve stem keys.

    Install the new valve seal assembly.

  2. NOTE: Apply oil to the outer diameter of the valve and valve tip prior to valve and seal installation. Valve must rotate freely.

    Install the valve(s) into the guide.

  3. Install the valve spring and valve spring retainer.
  4. NOTE: Verify that the valve stem keys are correctly seated after removal of the Valve Spring Compressor or engine damage may occur.

    Using the Valve Spring Compressor, install the valve stem keys.

    • Verify that the valve stem keys are correctly seated.
scientia non olet · About LEMON Manuals