Receiver Drier - 2.0L GTDI, 3.5L GTDI: Installation
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- To install, reverse the removal procedure.
- Install new gaskets seals and O-rings seals.
- Add the correct amount of clean Polyalkylene Glycol (PAG) oil to the refrigerant system, REFER to REFRIGERANT OIL ADDING .
- Evacuate, leak test and charge the refrigerant system. REFER to AIR CONDITIONING (A/C) SYSTEM RECOVERY, EVACUATION AND CHARGING .