Driveshaft Inspection

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Driveline vibration exhibits a higher frequency and lower amplitude than high speed shake. Driveline vibration is directly related to the speed of the vehicle and is noticed at various speeds. Driveline vibration can be perceived as a tremor in the floorpan or heard as a rumble, hum or boom.

NOTE: Refer to GENERAL SPECIFICATIONS for all runout specifications.

NOTE: Do not make any adjustments before carrying out a road test. Do not change the tire pressure or the vehicle load.

Carry out a visual inspection of the vehicle. Operate the vehicle and verify the condition by reproducing it during the road test.
- The concern should be directly related to vehicle road speed, not affected by acceleration or deceleration or could not be reduced by coasting in NEUTRAL.
With the vehicle in NEUTRAL, position it on a hoist. REFER to JACKING AND LIFTING , Lifting Points.
Inspect the driveshaft for damage, undercoating or incorrectly seated U-joint. Rotate the driveshaft slowly by hand and feel for binding or end play in the U-joint trunnions. Install a new driveshaft if damaged. After any corrections or new components are installed, recheck for the vibration at the road test speed.
- If the vibration is gone, test drive the vehicle.
- If the vibration persists or the driveshaft passes visual inspection, measure the driveshaft runout.