LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 226 (Automatic Transmission - 6F35) >> Removal And Installation >> Solenoid Body Leadframe >> Installation

Solenoid Body Leadframe: Installation

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install 307-636 in the solenoid body to align the leadframe for installation.
    G08031016Courtesy of FORD MOTOR CO.
  2. Position the leadframe on the 307-636 and carefully install the leadframe by pushing straight down into the solenoids.
  3. Remove the 307-636.
    G08031016Courtesy of FORD MOTOR CO.
  4. Install the 5 leadframe screws.
    G08031018Courtesy of FORD MOTOR CO.
  5. Connect the OSS  sensor electrical connector.
    G08030932Courtesy of FORD MOTOR CO.
  6. Connect the TR  sensor electrical connector.
    G08030931Courtesy of FORD MOTOR CO.
  7. Install the main control-to-cover seal.
    G08030933Courtesy of FORD MOTOR CO.
  8. Install the main control cover. Refer to MAIN CONTROL COVER .
scientia non olet · About LEMON Manuals