LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 222 (Engine Mechanical -3.5L Ti-VCT) >> Removal And Installation >> Crankshaft Front Seal >> Removal

Crankshaft Front Seal: Removal

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. REFER to JACKING AND LIFTING , Lifting Points.
  2. Remove the crankshaft pulley. Refer to CRANKSHAFT PULLEY .
  3. Using 303-409 T92C-6700-CH, remove and discard the crankshaft front seal.
    G08028948
  4. Inspect the crankshaft seal bore in the front cover for any damage or casting imperfections that may effect the crank seal outer diameter sealing. Repair/replace as necessary.
scientia non olet · About LEMON Manuals