LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (Engine Mechanical -2.0L GTDI) >> Removal And Installation >> Valve Seals >> Removal

Valve Seals: Removal

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure.
  1. Remove the valve spring. Refer to VALVE SPRINGS .
  2. Remove and discard the valve seal.
    1. Position 303-468 T94P-6510-AH and 307-005 T59L-100-B over the seal.
    2. Pull up on 307-005 T59L-100-B and 303-468 T94P-6510-AH and remove the seal.
      G08028647
scientia non olet · About LEMON Manuals