Removal And Installation: Camshafts: Removal
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
During engine repair procedures, cleanliness is extremely important. Any foreign material (including any material created while cleaning gasket surfaces) that enters the oil passages, coolant passages or the oil pan can cause engine failure.
NOTE:
Do not rotate the camshafts unless instructed to in this procedure. Rotating the camshafts or crankshaft with timing components loosened or removed can cause serious damage to the valves and pistons.
- With the vehicle in NEUTRAL, position it on a hoist. REFER to JACKING AND LIFTING .
- Check the valve clearance. Refer to VALVE CLEARANCE CHECK .
- Remove the camshaft phaser and sprockets. Refer to CAMSHAFT PHASER AND SPROCKET .
-
NOTE: The Camshaft Alignment Tool is for camshaft alignment only. Using this tool to prevent engine rotation can result in engine damage.
Remove the Camshaft Alignment Tool from the rear of both of the camshaft slots.
- Remove the 2 bolts and the 2 VCT
solenoids.
- Remove the 3 bolts and the front camshaft bearing cap.
-
NOTE: Failure to follow the camshaft loosening procedure can result in damage to the camshafts.NOTE: Note the position of the camshaft lobes on the No. 1 cylinder for installation reference.NOTE: Inspect the camshaft bores for any scratches that can be felt by hand.
Remove the camshafts from the engine.