Camshaft Phaser and Sprocket - RH: Removal

WARNING: This page is about a different car, the 2013 Ford F-350 Super Duty and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Remove the timing drive components. For additional information, refer to TIMING DRIVE COMPONENTS .
NOTE: Damage to the camshaft phaser and sprocket assembly will occur if mishandled or used as a lifting or leveraging device.

NOTE: Only use hand tools to remove the camshaft phaser and sprocket assembly or damage may occur to the camshaft or camshaft phaser and sprocket.

Using a 26 mm (1.023 in) wrench on the flats of the camshaft to secure the camshaft, remove the 3 RH camshaft phaser and sprocket bolts and the camshaft phaser and sprocket.
- Discard the 3 camshaft phaser and sprocket bolts.
  
  Fig 1: Locating Camshaft Phaser
  Courtesy of FORD MOTOR CO.
Remove and discard the Variable Camshaft Timing (VCT) system oil filter.

Fig 2: Removing Variable Camshaft Timing System Oil Filter
Courtesy of FORD MOTOR CO.