LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Engine Mechanical - 3.5L GTDI) >> In-Vehicle Repair >> Flexplate >> Installation

In-Vehicle Repair: Flexplate: Installation

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: One of the 8 flexplate holes are offset so the flexplate can only be installed in one position.

    Install the flexplate and the 8 bolts.

    • Tighten in the sequence shown in illustration to 80 Nm (59 lb-ft).
      G09069498
  2. Install the transaxle. REFER to TRANSMISSION - FRONT WHEEL DRIVE (FWD) or TRANSMISSION - ALL WHEEL DRIVE (AWD) .
  3. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
scientia non olet · About LEMON Manuals