Exhaust Manifold - RH: Installation

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

Install 8 new RH exhaust manifold studs.
- Tighten to 12 Nm (106 lb-in).
NOTE: Failure to tighten the exhaust manifold nuts to specification a second time will cause the exhaust manifold to develop an exhaust leak.

Install a new gasket, RH exhaust manifold and 8 new nuts. Tighten in 2 stages in the sequence shown in illustration:
- Stage 1: Tighten to 15 Nm (133 lb-in).
- Stage 2: Tighten to 20 Nm (177 lb-in).
Install the RH turbocharger. Refer to FUEL CHARGING AND CONTROLS - TURBOCHARGER, 3.5L GTDI .
Install the underbody air duct and the 3 twist lock retainers.