LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Engine Mechanical - 3.5L GTDI) >> In-Vehicle Repair >> Crankshaft Rear Seal >> Installation

Crankshaft Rear Seal: Installation

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Lubricate the seal lips and bore with clean engine oil prior to installation.

    Special Tool(s): Installer, Rear Main Seal 303-1250.

    Position the Rear Main Seal Installer onto the end of the crankshaft and slide a new crankshaft rear seal onto the tool.

    G09069400
  2. Special Tool(s): Installer, Rear Main Seal 303-1250 and Handle 205-153 (T80T-4000-W).

    Install the new crankshaft rear seal.

    G09069401
  3. Install the crankshaft sensor ring.
    G09069402
  4. Install the flexplate. Refer to FLEXPLATE .
  5. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
scientia non olet · About LEMON Manuals