Oil Cooler: Installation

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

Using new gaskets, install the oil cooler and the 6 bolts.
- Tighten in the sequence shown in illustration to 10 Nm (89 lb-in).
Install the 2 coolant hoses to the oil cooler.
- Remove the 2 hose clamp pliers.
NOTE: Do not lubricate the engine oil filter gasket.

Install a new engine oil filter.
- Tighten to 5 Nm (44 lb-in), then turn an additional 180 degrees.