LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Engine Mechanical - 3.7L Ti-VCT) >> Removal And Installation >> Engine Oil Pressure (EOP) Switch >> Installation

Engine Oil Pressure (EOP) Switch: Installation

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Apply Thread Sealant with PTFE to the EOP  switch threads prior to installation.

    Install the EOP  switch.

    • Tighten to 14 Nm (124 lb-in) plus an additional 180 degrees.
      G09066211
  2. Connect the EOP  switch electrical connector.
    G09066210
  3. Install the engine oil cooler. Refer to OIL COOLER .
scientia non olet · About LEMON Manuals