Crankshaft Rear Seal: Installation
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Clean all sealing surfaces with Motorcraft® Metal Surface Prep.
-
NOTE: Lubricate the seal lips and bore with clean Motorcraft® SAE 5W-20 Premium Synthetic Blend Motor Oil (US); Motorcraft® SAE 5W-20 Super Premium Motor Oil (Canada) prior to installation.
Position 303-1250 onto the end of the crankshaft and slide a new crankshaft rear seal onto the tool.
- Using 303-1250 and 205-153 T80T-4000-W, install the new crankshaft rear seal.
- Install the crankshaft sensor ring.
- Install the flexplate. Refer to FLEXPLATE .