LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Engine Mechanical - 3.7L Ti-VCT) >> Disassembly And Assembly Of Subassemblies >> Cylinder Head >> Disassembly

Cylinder Head: Disassembly

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If the components are to be reinstalled, they must be installed in the same positions. Mark the components for installation into their original locations.
  1. Using the 303-300 T87C-6565-A, 303-350 T89P-6565-A and 303-1249, remove the keys, retainer and spring.
    G08030181
  2. Remove and discard the valve stem seal.
    G08029340
  3. Remove the valve from the cylinder head.
    • Repeat the above steps for each valve.
      G08030183
  4. Remove the timing chain guide pin.
    G08030184
  5. Remove the timing chain tensioner arm pin from the RH cylinder head.
    G08030185
  6. Remove and discard the CHT  sensor from the RH cylinder head.
    G08030186
scientia non olet · About LEMON Manuals