Component testing procedure
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Horizontal circuit | 4 and 3 | Forward | Closed circuit |
| 6 and 2 | Closed circuit | ||
| 4 and 6 | Rearward | Closed circuit | |
| 3 and 2 | Closed circuit | ||
| Front Height circuit | 4 and 1 | Up | Closed circuit |
| 8 and 2 | Closed circuit | ||
| 4 and 8 | Down | Closed circuit | |
| 1 and 2 | Closed circuit | ||
| Rear Height circuit | 4 and 5 | Up | Closed circuit |
| 7 and 2 | Closed circuit | ||
| 4 and 7 | Down | Closed circuit | |
| 5 and 2 | Closed circuit |