Removal and Installation
WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
All safety belt components must be inspected and corrected as part of any collision repair. Inspect all safety belt components as prescribed by Safety Belt Inspection and Repair After a Collision . Failure to follow this instruction may result in incorrect operation of the safety belt system and increase the risk of serious personal injury or death in a crash.
- Remove the front seat. For additional information, refer to SEATING .
- Disconnect the safety belt buckle switch electrical connector.
- Remove the bolt and safety belt buckle.
- To install, tighten to 40 Nm (30 lb-ft).
- To install, reverse the removal procedure.
- Check the active restraint system for correct operation. For additional information, refer to the appropriate FUNCTIONAL TEST procedure in Safety Belt System in this information.