DTC Charts

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: This module utilizes a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.

BODY CONTROL MODULE B (BCM-B) DTC CHART

DTC	Description	Action
B109F:08	Intrusion Sensor Module: Bus Signal / Message Failures	GO to PINPOINT TEST E .
B109F:49	Intrusion Sensor Module: Internal Electronic Failure	INSTALL a new intrusion and inclination sensor. REFER to INTRUSION AND INCLINATION SENSOR . TEST the system for normal operation.
B109F:55	Intrusion Sensor Module: Not Configured	REFER to MODULE CONFIGURATION .
B109F:97	Intrusion Sensor Module: Component Or System Operation Obstructed Or Blocked	NOTE: The Body Control Module B (BCM-B) DTC B109F:97 is a continuous memory and on-demand DTC that sets when there are 3 successive failures of the intrusion and inclination sensor module to arm and there is no indication of a module fault and the communication link between the module and the BCM-B appears to have sufficient integrity. CHECK for any blockages/restrictions near the intrusion and inclination sensor that may hinder/affect the operation of the sensor.
All other DTCs	-	REFER to the Diagnostic Trouble Code (DTC) Chart in MULTIFUNCTION ELECTRONIC MODULES .

SMART JUNCTION BOX (SJB) DTC CHART

DTC	Description	Action
B1520	Hood Switch Circuit Open	GO to PINPOINT TEST C .
B2100	Door Driver Key Cylinder Switch Failure	GO to PINPOINT TEST A .
All other DTCs	-	REFER to the Diagnostic Trouble Code (DTC) Chart in MULTIFUNCTION ELECTRONIC MODULES .