LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 189 (Windows And Glass - Glass, Frames And Mechanisms) >> General Procedures >> Glass Reseal - Windshield

Glass Reseal - Windshield

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
MATERIAL SPECIFICATIONS

Item Specification
Dow Urethane Adhesive
Betaseal™ Express		 -
Sika Urethane Adhesive
Sika Tack ASAP		 -
Ultra-Clear Spray Glass Cleaner
ZC-23		 ESR-M14P5-A

Coupe 

  1. Remove the RH and LH A-pillar trim panels. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Remove the overhead console.
  3. Remove the LH and RH sun visors.
  4. Lower the front portion of the headliner and block with a suitable material.

    Convertible 

  5. Remove the LH and RH A-pillar trim panel and the header trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .

    All vehicles 

  6. Remove the cowl vent screen. For additional information, refer to FRONT END BODY PANELS .
  7. Clean the interior and exterior of the windshield glass surface with glass cleaner.
  8. Cut the urethane adhesive applicator tip to specification.
    Fig 1: Identifying Urethane Adhesive Applicator Tip Cutting Dimension
    G06070969Courtesy of FORD MOTOR CO.
  9. NOTE: Use either a high-ratio, electric or battery-operated caulk gun that applies the urethane adhesive with less effort and a continuous bead.
    NOTE: Make sure all gaps in the urethane adhesive are smoothed into one continuous bead.

    Apply urethane adhesive over top of the existing urethane adhesive.

    • Apply the urethane adhesive to the top and sides of the windshield from the interior of the vehicle.
    • Apply the urethane adhesive to the bottom of the windshield from the exterior of the vehicle.
  10. NOTE: The urethane adhesive must cure for a minimum of one hour before testing for air or water leaks.

    After the urethane adhesive has cured, check the windshield glass seal for air or water leaks through the urethane adhesive bead and add urethane adhesive as necessary.

  11. Install the cowl vent screen. For additional information, refer to FRONT END BODY PANELS .

    Convertible 

  12. Install the header trim panel and the LH and RH A-pillar trim panels. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .

    Coupe 

  13. Position the front portion of the headliner.
  14. Install the LH and RH sun visors.
  15. Install the overhead console.
  16. Install the RH and LH A-pillar trim panels. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .

    All vehicles 

  17. Install and adjust the wiper blade and pivot arms as necessary. For additional information, refer to WIPERS AND WASHERS .
scientia non olet · About LEMON Manuals