LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 185 (Anti-Theft System - Passive Anti-Theft System) >> Removal And Installation >> Passive Anti-Theft System (PATS) Transceiver >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering column opening trim panel. For additional information, refer to INSTRUMENT PANEL - EXPLODED VIEW .
  2. Remove the 3 screws and the lower steering column shroud.
  3. Disconnect the Passive Anti-Theft System (PATS) transceiver electrical connector.
  4. Release the clips and remove the PATS transceiver.
  5. NOTE: Replacement of the PATS transceiver does not require the Integrated Keyhead Transmitters (IKTs) to be programmed into the Instrument Panel Cluster (IPC) again.

    To install, reverse the removal procedure.

scientia non olet · About LEMON Manuals