LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 184 (Fuel Charging And Controls - 5.8L (4V)) >> Removal And Installation >> Throttle Body >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the Air Cleaner (ACL) outlet pipe, refer to INTAKE AIR DISTRIBUTION & FILTERING .
  2. Disconnect the Throttle Position (TP) sensor electrical connector.
  3. Disconnect the electronic throttle control electrical connector.
  4. Remove the 4 bolts and the Throttle Body (TB) and discard the gasket.
    • Tighten to 10 Nm (89 lb-in).
  5. To install, reverse the removal procedure.
    • Install a new TB gasket.
scientia non olet · About LEMON Manuals