Oil Cooler - Engine Mounted: Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Clean the sealing surfaces with Motorcraft® Metal Surface Prep. Follow the directions on the packaging. Inspect the mating surfaces.

Using new gaskets, install the oil cooler and the 6 bolts. Tighten in the sequence shown in illustration in 2 stages.
- Stage 1: Tighten to 9 Nm (80 lb-in).
- Stage 2: Tighten an additional 60 degrees.
  
  Fig 1: Identifying Oil Cooler Thermostat Bolts Tightening Sequence
  Courtesy of FORD MOTOR CO.
Install the generator. Refer to CHARGING SYSTEM .
Fill and bleed engine cooling system. Refer to ENGINE COOLING .