LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 180 (Engine Mechanical - 5.8L (4V)) >> In-Vehicle Repair >> Flywheel >> Removal

In-Vehicle Repair: Flywheel: Removal

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the clutch. For additional information, refer to CLUTCH .
  2. Remove the 8 flywheel bolts.
  3. NOTE: The flywheel is a press fit on the crankshaft pilot. Do not use screwdrivers or prybars to remove the flywheel or damage to the flywheel or engine may occur.

    Remove the flywheel.

    • Install 2 of the removed flywheel bolts in the 2 holes shown in illustration on the flywheel flange.
    • Tighten the 2 bolts evenly to push the flywheel off the crankshaft pilot.
      Fig 1: Locating Flywheel Bolts Holes
      G06394765Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals