LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 180 (Engine Mechanical - 5.8L (4V)) >> In-Vehicle Repair >> Flywheel >> Installation

In-Vehicle Repair: Flywheel: Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the flywheel on the crankshaft pilot and start the 8 flywheel bolts.
  2. Tighten the flywheel bolts evenly in the sequence shown in illustration to fully seat the flywheel on the crankshaft pilot.
    • Tighten to 80 Nm (59 lb-ft).
      Fig 1: Identifying Flywheel Bolts Tightening Sequence
      G06394766Courtesy of FORD MOTOR CO.
  3. Install the clutch. For additional information, refer to CLUTCH .
  4. After completing the repairs, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.
scientia non olet · About LEMON Manuals