LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 180 (Engine Mechanical - 5.8L (4V)) >> In-Vehicle Repair >> Crankshaft Rear Seal >> Installation

Crankshaft Rear Seal: Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Lubricate the inner lip of the crankshaft rear seal with clean engine oil.

    Using the Crankshaft Rear Oil Seal Installers, install the crankshaft rear seal.

    Fig 1: Installing Crankshaft Rear Oil Seal Using Special Tools
    G06126455Courtesy of FORD MOTOR CO.
  2. Using the Crankshaft Rear Oil Slinger Installer, install the crankshaft rear oil slinger.
    Fig 2: Installing Crankshaft Rear Oil Slinger Using Crankshaft Rear Oil Slinger Installer
    G06394776Courtesy of FORD MOTOR CO.
  3. Install the flywheel. For additional information, refer to FLYWHEEL .
scientia non olet · About LEMON Manuals