LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 180 (Engine Mechanical - 5.8L (4V)) >> In-Vehicle Repair >> Crankshaft Pulley >> Removal

Crankshaft Pulley: Removal

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to JACKING & LIFTING .
  2. Remove the cooling fan assembly. Refer to ENGINE COOLING SYSTEM -- MUSTANG .
  3. Rotate the Supercharger (SC) drive belt tensioner clockwise and remove the drive belt from the SC drive pulley.
    Fig 1: Rotating SC Drive Belt Tensioner Clockwise
    G07474976Courtesy of FORD MOTOR CO.
  4. Rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the idler pulley.
    Fig 2: Rotating Accessory Drive Belt Tensioner Clockwise
    G07474996Courtesy of FORD MOTOR CO.
  5. Position the accessory drive belt and SC drive belt away from the crankshaft pulley.
  6. Using the Strap Wrench, remove the crankshaft pulley bolt and the washer.
    • Discard the bolt.
      Fig 3: Removing/Installing Crankshaft Pulley Bolt And Washer Using Strap Wrench
      G07408870Courtesy of FORD MOTOR CO.
  7. Using the 3 Jaw Puller, remove the crankshaft pulley.
    Fig 4: Removing Crankshaft Pulley Using Jaw Puller
    G06394606Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals