Functional Test - Safety Belt Buckle and Tongue
WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Always install a new safety belt buckle and safety belt or safety belt retractor as a matched set.
The safety belt buckle and tongue assembly must operate freely during the latching and unlatching function. Fasten the safety belt by inserting the tongue (male portion) into the buckle (female portion).
- Verify the following during the latching sequence:
- Tongue insertion is not hindered by excessive effort.
- A click is heard when the safety belt buckle latches the tongue.
- Verify the system integrity by forcefully pulling on the safety belt webbing.
- Unlatch the safety belt by fully depressing the safety belt buckle release button and allowing the safety belt to release and retract.
- Verify the following during the unlatching process:
- Push-button depression does not require excessive effort.
- The tongue can be removed easily from the buckle when the button is depressed.
- Repeat the above steps 3 times.
- If the functional test reveals a concern(s), install a new safety belt and safety belt buckle or safety belt retractor and safety belt buckle as required.
- Install a new safety belt and safety belt buckle or safety belt retractor and safety belt buckle if no obvious concerns are noticed and the complaint has been verified.