Removal and Installation
WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- Drain the engine cooling system. Refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
- Remove the 2 bolts and position aside the thermostat housing cover and hose assembly.
- To install, tighten to 10 Nm (89 lb-in).
- Remove the O-ring seal and the thermostat.
- Discard the O-ring seal.
- To install, reverse the removal procedure.
- Lubricate the new O-ring seal with clean engine coolant.
- Fill and bleed the cooling system. Refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .