LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (Engine Cooling System) >> Removal And Installation >> Coolant Pump - 3.7L >> Removal

Coolant Pump - 3.7L: Removal

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner outlet pipe. Refer to INTAKE AIR DISTRIBUTION & FILTERING .
  2. Loosen the 4 coolant pump pulley bolts.
  3. Remove the accessory drive belt. Refer to ACCESSORY DRIVE .
  4. NOTE: Cover the A/C compressor belt to prevent coolant contamination of the belt.

    Completely cover the A/C compressor belt with waterproof plastic.

  5. Remove the thermostat housing. Refer to THERMOSTAT HOUSING - 3.7L .
  6. Remove the 4 bolts and the coolant pump pulley.
  7. Remove the 7 bolts and the coolant pump.
    • Remove and discard the gasket and the O-ring seal in the coolant pump.
scientia non olet · About LEMON Manuals