In-Vehicle Repair: Flywheel: Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: One of the 8 flywheel holes are offset so the flywheel can only be installed in one position.

Install the dual mass flywheel and the 8 bolts and tighten in sequence shown in illustration.
- Tighten to 80 Nm (59 lb-ft).
  
  Fig 1: Identifying Dual Mass Flywheel Bolts Tightening Sequence
  Courtesy of FORD MOTOR CO.
Install the clutch. For additional information, refer to CLUTCH .
After completing the repairs, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.