LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 174 (Clutch Controls) >> Removal And Installation >> Clutch Slave Cylinder >> Installation

Clutch Slave Cylinder: Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new retaining clip.
    Fig 1: Locating Retaining Clip
    G06382485Courtesy of FORD MOTOR CO.
  2. Position the clutch slave cylinder to the transmission, inserting the tube through the retaining clip. Install the 2 clutch slave cylinder bolts.
    • Tighten to 11 Nm (97 lb-in).
  3. Install the clutch hydraulic tube connector.
  4. NOTE: Before securing the transmission to the engine, connect the hydraulic tube to the clutch hydraulic tube connector. When connecting the hydraulic tube, a click will be heard when the tube is correctly connected. Pull on the tube to make sure it is locked in the fitting.

    Install the transmission. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION - MT82 GETRAG 6-SPEED or MANUAL TRANSAXLE/TRANSMISSION - TR6060 .

  5. Bleed the clutch hydraulic system. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION AND CLUTCH - GENERAL INFORMATION .
scientia non olet · About LEMON Manuals