LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 167 (Wiper System & Washer System) >> Removal And Installation >> Wiper Mounting Arm and Pivot Shaft >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the RH and LH cowl vent screens. For additional information, refer to FRONT END BODY PANELS .
  2. Remove the 3 bolts and the windshield wiper mounting arm and pivot shaft.
    • To install, tighten to 7 Nm (62 lb-in).
  3. Disconnect the windshield wiper motor electrical connector.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals