Washer Jet: Removal
WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- Lower the rear part of the hood insulator to access the washer jet-to-washer jet hose C-lock coupler.
- Disconnect the washer jet-to-washer jet hose. For additional information, refer to C-LOCK COUPLER .
-
NOTE: When prying on a component, a non-marring tool must be used or damage to the component may occur.
Remove the washer jet.
- Insert a sturdy plastic card between the washer jet and the hood. Press forward to release the retaining clip.