LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 165 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Luggage Compartment Lid Lock Cylinder - Convertible >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat backrest. For additional information, refer to SEATING .
  2. Remove the safety belt retractor bolt.
    • To install, tighten to 40 Nm (30 lb-ft).
  3. Disconnect the luggage compartment lid latch actuator cable from the luggage compartment lid lock cylinder.
  4. Slide the luggage compartment lid lock cylinder retainer off the lock cylinder.
  5. Remove the luggage compartment lid lock cylinder.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals