Pinpoint Test I: An Individual Button/Feature Is Inoperative From The RKE Transmitter
WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The panic feature will only operate when the key is in the OFF or LOCK positions.
- I1 VERIFY THE DOOR LOCK OPERATION
- Press the lock and unlock button on the driver door lock control switch while observing the door lock operation.
- Do the door locks operate correctly?
- Yes : GO to I2.
- No : GO to Symptom Chart - Electrical .
- I2 VERIFY THE HORN OPERATION
- Enter the following diagnostic mode on the scan tool: SJB DataLogger.
- Select the SJB PID (HORN) and active command the horn on.
- Does the horn sound when commanded on?
- Yes : GO to I3.
- No : REFER to HORN .
- I3 VERIFY THE HAZARD LAMP OPERATION
- Place the hazard switch in the ON position.
- Do the hazard lamps operate correctly?
- Yes : GO to I4.
- No : REFER to EXTERIOR LIGHTING .
- I4 VERIFY THE LUGGAGE COMPARTMENT LID RELEASE OPERATION
- Press the luggage compartment lid release button, located next to the headlamp switch.
- Does the luggage compartment lid release?
- Yes : REPLACE the inoperative IKT and PROGRAM the IKT individually or PROGRAM all the IKTs. REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) for the programming procedures. If all the IKTs are to be programmed, INFORM the customer that any IKTs not present need to be programmed. TEST the system for normal operation.
- No : GO to Symptom Chart - Electrical .