Passenger Airbag: Removal

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.

NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

Depower the SRS. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .
Lower the glove compartment door.
Remove the 4 bolts and position the Accessory Protocol Interface Module (APIM) aside.

Fig 1: Locating Accessory Protocol Interface Module And Mounting Bolts
Courtesy of FORD MOTOR CO.
Disconnect the passenger air bag module electrical connector.
Remove the 2 air bag module bolts.
Through the glove box opening, detach the air bag trim cover clips from the instrument panel and remove the passenger air bag module.