Driveshaft - 5.8L (4V): Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If new driveshaft flange bolts are not available, coat the threads of the original bolts with threadlock and sealer and reuse the original washers and spacers.

NOTE: The driveshaft flanges fit tightly on the transmission output flange pilot. To make sure that the driveshaft flange seats squarely on the transmission output flange, tighten the driveshaft flange bolts evenly in a cross pattern.

To install, reverse the removal procedure.