LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Rear Drive Axle/Differential (Ford 8.8")) >> In-Vehicle Repair >> Rear Wheel Bearing and Axle Shaft Seal >> Removal

Rear Wheel Bearing and Axle Shaft Seal: Removal

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the axle shaft. Refer to AXLE SHAFT .
  2. NOTE: If the axle shaft oil seal is leaking, the axle housing vent may be plugged.

    Using the Slide Hammer and Axle Bearing Remover, remove the rear wheel bearing and axle shaft oil seal.

    Fig 1: Removing Rear Wheel Bearing And Axle Shaft Oil Seal Using Slide Hammer And Axle Bearing Remover
    G06384502Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals