Seat Cushion Heater Mat: Removal
WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Do not reinstall any heater mat or foam pad after removal. The adhesive will not adhere correctly to the foam pad, causing it to bunch up or shift out of place. A new heater mat and a new foam pad must be installed. Failure to follow these instructions can result in heated seat component damage and system failure.
NOTE:
Do not install a new heater mat on a front passenger seat cushion. Install a new Occupant Classification Sensor (OCS) system service kit. Failure to follow this instruction can cause incorrect OCS system operation. Refer to
SUPPLEMENTAL RESTRAINT SYSTEM
for the Occupant Classification Sensor Removal and Installation procedure.
NOTE:
For parts identification and location, refer to SEAT - EXPLODED VIEW, FRONT .
- Remove the seat cushion cover. For additional information, refer to SEAT CUSHION COVER - FRONT .
- Disconnect the cushion heater mat electrical connector.
- Note wire harness routing for correct installation.
- Remove and discard the cushion foam pad and heater mat.