LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Seat System - Seats) >> Removal And Installation >> Seat Cushion Heater Mat >> Installation

Seat Cushion Heater Mat: Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new cushion foam pad to the cushion frame.
  2. NOTE: Install the new heater mat straight on the foam pad and without any wrinkles that may show through the backrest cover after installation.

    Install the heater mat to the foam pad.

    • Remove the paper strips from the new heater mat.
    • Align the heater mat square to the cushion foam pad.
    • Apply the heater mat flat on the foam pad surface without any wrinkles and correctly tuck into the valley of the foam pad.
  3. Route the seat cushion heater mat wire harness as noted in removal and connect the electrical connector.
  4. Install the seat cushion cover. For additional information, refer to SEAT CUSHION COVER - FRONT .
scientia non olet · About LEMON Manuals