Lumbar Control Switch: Removal

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For parts identification and location, refer to SEAT - EXPLODED VIEW, FRONT .

Remove the clip and recline handle.
- Access the clip from between the cushion cover and side shield.
NOTE: Do not reinstall the cushion side shield or side shield retainers after removal. These are one-time-use items that become damaged during removal and may not remain attached if reinstalled. Install a new side shield during seat assembly.

Remove and discard the cushion side shield.
- Remove the screw at the rear of the cushion side shield.
- Separate the side shield and retainers from the seat.
- If equipped, remove the seat control switch.
  - Disconnect the electrical connector.
  - Remove the knob.
  - Remove the switch from the side shield.
- Remove the power lumbar switch.
  - Disconnect the electrical connector.
  - Remove the switch from the side shield.
- Remove and discard the cushion side shield.
- Remove any remaining retainers from the seat and discard.