Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For parts identification and location, refer to SEAT - EXPLODED VIEW, FRONT .

Remove the seat backrest. For additional information, refer to SEAT BACKREST - FRONT .
Release the backrest cover pin-type retainers and J-clip.

Fig 1: Locating Backrest Cover Pin-Type Retainers And J-Clip
Courtesy of FORD MOTOR CO.
Release the J-clip at the back of the backrest trim cover and separate the hook-and-loop strip.
NOTE: Use care when separating the seat backrest cover from the hook-and-loop strips. The hook-and-loop strips may be torn from the foam pad.

Partially invert the seat backrest cover to access the lumbar assembly.
Detach the 4 hooks from the backrest frame and remove the lumbar assembly.
- If equipped, disconnect the power lumbar electrical connector.
  
  Fig 2: Detaching Backrest Frame Hooks
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.