Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

Remove the stabilizer bar. For additional information, refer to STABILIZER BAR .
NOTE: To aid removal, apply a light coat of silicone lubricant to the necessary parts of the rear stabilizer bar and the inside diameter of the stabilizer bar bushing and link.

Remove the stabilizer bar bushing and link.
1. Slide the bushing off of the stabilizer bar.
2. Slide the link off of the stabilizer bar.
  
  Fig 1: Sliding Link Off Of Stabilizer Bar
  Courtesy of FORD MOTOR CO.
NOTE: The stabilizer bar links and bushings are vehicle specific (convertible and coupe). Make sure the correct link and bushing go on the correct vehicle.

NOTE: To aid installation, apply a light coat of silicone lubricant to the necessary parts of the rear stabilizer bar and the inside diameter of the stabilizer bar bushing and link.

To install, reverse the removal procedure.