Gearshift Lever Exploded View

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Manual Transmission Gearshift Lever With Torque Specifications

Courtesy of FORD MOTOR CO.

Item	Part Number	Description
1	7213	Gearshift lever knob
2	7277	Gearshift lever boot
3	7210	Upper gearshift lever
4	W707137	Gearshift lever shield nuts
5	W505424	Gearshift lever shield bolts
6	7277	Gearshift lever shield
7	-	Upper gearshift lever bolts
8	7400	Gearshift lever assembly
9	7314	Gearshift lever retainers
10	W500324	Gearshift lever bolt

Remove the upper gearshift lever knob and position the floor console finish panel aside.
- Turn the upper gearshift lever knob in a counterclockwise direction.
  
  Fig 2: Locating Upper Gearshift Lever Knob And Floor Console Finish Panel
  Courtesy of FORD MOTOR CO.
Remove the upper gearshift lever bolts and the upper gearshift lever.
- To install, tighten to 35 Nm (26 lb-ft).
  
  Fig 3: Locating Upper Gearshift Lever Bolts
  Courtesy of FORD MOTOR CO.
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the 4 subframe cross brace bolts and the subframe cross brace.
- To install, tighten to 48 Nm (35 lb-ft).
  
  Fig 4: Locating Subframe Cross Brace Bolts
  Courtesy of FORD MOTOR CO.
Using a suitable transmission jack, support the transmission.
Remove the 4 rear transmission crossmember bolts.
- To install, tighten to 63 Nm (46 lb-ft).
  
  Fig 5: Locating Rear Transmission Crossmember Bolts
  Courtesy of FORD MOTOR CO.
Remove the driveshaft. For additional information, refer to DRIVESHAFT .
Lower the transmission enough to access the gearshift lever nuts.
Remove the 2 rear gearshift lever nuts.
- To install, tighten to 11 Nm (97 lb-in).
  
  Fig 6: Locating Rear Gearshift Lever Nuts
  Courtesy of FORD MOTOR CO.
Remove the gearshift lever assembly.
1. Insert a pick into the lower hole to unlock the clip.
2. Rotate the gearshift lever retainers, then remove the retainers.
3. Remove the gearshift lever bolt.
  To install, tighten to 40 Nm (30 lb-ft).
4. Remove the gearshift lever assembly from the vehicle.
  
  Fig 7: Locating Gearshift Lever Assembly With Torque Specifications
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- Make sure to snap the gearshift lever retainers into the locked position.
- Carefully position the gearshift lever into the lower shift boot. Make sure the lever is through the boot.
  
  Fig 8: Positioning Gearshift Lever Into Lower Shift Boot
  Courtesy of FORD MOTOR CO.