LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Automatic Transmission (6R80)) >> In-Vehicle Repair >> Output Shaft Seal >> Removal

Output Shaft Seal: Removal

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in PARK, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the driveshaft. For additional information, refer to DRIVESHAFT .
  3. NOTE: The output shaft flange nut has been staked to prevent it from coming loose. Prior to removing the nut, remove the stake to prevent damage to the output shaft.

    Remove and discard the output shaft flange nut.

    Fig 1: Locating Output Shaft Flange Nut
    G06456435Courtesy of FORD MOTOR CO.
  4. Remove the output shaft flange.
    Fig 2: Identifying Output Shaft Flange
    G06127229Courtesy of FORD MOTOR CO.
  5. Using the Input Shaft Oil Seal Remover and Slide Hammer, remove and discard the output shaft seal.
    Fig 3: Removing Output Shaft Seal
    G06127223Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals