DTC P262A: Fuel Injector: Pilot Injection Not Learned
WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
DTC P262A: FUEL INJECTOR: PILOT INJECTION NOT LEARNED
| Description: | This DTC sets when the PCM is unable to learn any data for pilot injection correction for 100 seconds while the zero fuel calibration monitor entry conditions are satisfied. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Carry out the power balance test to verify cylinders contribution. Disregard any DTCs set as a result of the power balance test. Single or inconsistent non-contributing power cylinder traces may be caused by a natural variation in a crankshaft speed and should be ignored. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST M . | ||