DTC P0219: Engine OVERSPEED Condition

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

DTC P0219: ENGINE OVERSPEED CONDITION

Description:	This DTC sets when an engine overspeed condition is detected. Under normal conditions engine overspeed is prevented by reducing the injected fuel mass but can happen if the engine is running by oil ingestion. To prevent short engine overspeeds from setting the DTC, the overspeed must last for a greater time period than a calibrated limit.
Possible Causes:	Incorrect engine oil level Incorrect RPM signal Accelerator pedal to floor mat interference Aftermarket performance products Oil contaminated charge air cooler (CAC) Incorrect downshift Crankshaft position (CKP) sensor interference Camshaft position (CMP) sensor interference Excessive engine speed
Diagnostic Aids:	The DTC indicates the vehicle has been operated in a manner which caused the engine speed to exceed 4, 000 RPM for greater than 3 seconds.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	Refer to the Description, Possible Causes and Diagnostic Aids for the DTC in this table. Refer to the appropriate articles related to the description, possible causes and diagnostic aids.