DTC P0108: Manifold Absolute Pressure (Map)/Barometric Pressure (BARO) Sensor High
WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
DTC P0108: MANIFOLD ABSOLUTE PRESSURE (MAP)/BAROMETRIC PRESSURE (BARO) SENSOR HIGH
| Description: | This DTC sets when the MAP signal voltage is higher than a specified value indicating a short to voltage. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | The presence of this DTC may indicate that the vehicle is operating in derate mode and may experience a loss of power. After repair, the vehicle may still display a system warning message. Drive the vehicle until the system warning message has cleared from the instrument cluster message center. If the MAP sensor operating voltage is greater than 4.75 volts for greater than 2 seconds, a concern is indicated. |
||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST E . | ||