LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Sunroof - Roof Opening Panel) >> Removal And Installation >> Roof Opening Panel Weatherstrip >> Removal

Roof Opening Panel Weatherstrip: Removal

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The roof opening panel must be initialized when repairs are carried out on any part of the roof opening panel, including: whenever the roof opening panel has been removed from the roof opening panel assembly, a new roof opening panel motor/module has been installed or when a new roof opening panel assembly has been installed. For additional information, refer to ROOF OPENING PANEL MOTOR INITIALIZATION .
  1. Remove the roof opening panel glass. For additional information, refer to ROOF OPENING PANEL GLASS .
  2. Place roof opening panel, topside up, on a worktable. Take care to support the glass assembly from below to prevent damaging the mounting tabs.
  3. Remove the old roof opening panel weatherstrip by pulling up on the weatherstrip.
    Fig 1: Removing Roof Opening Panel Weatherstrip
    G06135546Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals