Windshield Glass: Removal

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Remove the cowl panel grille. For additional information, refer to FRONT END BODY PANELS .
Remove the interior rear view mirror. For additional information, refer to REAR VIEW MIRRORS .
Remove the A-pillar trim panels. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
Remove the overhead console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
Remove the sun visors.
Lower the front portion of the headliner.
Cover the seats, instrument panel and hood to prevent possible damage.
Before cutting the urethane adhesive, remove dirt and other foreign material from the windshield pinch weld area.
- Use a clean shop towel or oil-free compressed air.
NOTE: See manufacturer's instructions before using the Deluxe Windshield Removal Tool.

Lubricate the urethane adhesive with water to aid the Deluxe Windshield Removal Tool when cutting the urethane adhesive.
WARNING: Wear eye protection when servicing a vehicle. Failure to follow this instruction may result in serious personal injury.

WARNING: Wear protective gloves when handling components or parts that have pointed or sharp edges. Failure to follow this instruction may result in serious personal injury.

NOTE: To avoid rust formation, use extreme care not to scratch the paint or primer, or otherwise damage the pinch weld during glass removal.

NOTE: Insert the blade into the Deluxe Windshield Removal Tool so that the flat side is against the glass. This will leave the entire urethane adhesive bead on the pinch weld and allow a dry fit of the replacement windshield glass.

NOTE: Support the windshield glass as necessary to prevent the glass from dropping while cutting the urethane adhesive.

Insert the Deluxe Windshield Removal Tool at the upper center of the windshield glass and work toward the bottom corners.

Fig 1: Cutting Remaining Urethane Adhesive
Courtesy of FORD MOTOR CO.
Using The Pumper, distance the windshield from the body.

Fig 2: Identifying Distance Of Windshield From Body
Courtesy of FORD MOTOR CO.
Insert the Deluxe Windshield Removal Tool into the bottom of the urethane adhesive and cut from corner to corner.

Fig 3: Cutting Remaining Urethane Adhesive
Courtesy of FORD MOTOR CO.
NOTE: If reinstalling the windshield glass, tape the windshield at the windshield stops to aid in alignment of the glass during installation.

Carefully remove the windshield glass from the vehicle and place on a stable work surface.